===============================================================================
                                W A V E C O M
===============================================================================

OPEN AT V2.00
Updated : January 22th, 2003

===============================================================================

(To print this file : use Notepad and remove all margins and default header.)

                       ---------------------------------
                              Content of this file
                       ---------------------------------

Phone Display on Parallel LCD Sample application description

I.      Changes
II.     Application description



   
I - Changes
===========

* 03/01/22  -   V2.00
  Initial revision.


II - Application description
============================

 This application uses a standard LCD plugged on the parallel bus to display
information, such as the current operator name, and the remote party phone
number on an incoming call.

 First it opens the parallel bus and set-up the LCD in order to display further
informations. Then it sends the AT+COPS command to get the operator name. This
name is displayed on the LCD, and cleared if the application receive a +WIND: 0
indication.

 On a RING unsolicited indication, the application sends the AT+CLCC command to
get the remote party phone number, and display it on the LCD. At the end of
call (with ATH command or +WIND: 6 indication), the number is cleared, and the
operator name is displayed again.